ip地址切換批處理腳本分享

字號:


    這篇文章主要介紹了ip地址切換批處理腳本,改一下就可以就成IP地址切換器了,如果你有二個網絡在使用一定會用的到,我在公司就是這么做的,需要的朋友可以參考下吧
    代碼如下:
    @echo off
    rem # ----------------------------------
    rem # 接口 IP 配置
    rem # ----------------------------------
    echo "=========IP 控制管理=========="
    echo "=> d: 自動獲取IP"
    echo "=> h: 寢室 IP地址:66.168.1.8"
    echo "=> r: 公司網絡 IP地址:192.168.250.173"
    echo "請輸入對應的序號d,h,r,按回車鍵結束: "
    set /p ch=
    if %ch%=="" echo "You input null"&goto :EOF
    set case=d,h,t,w>nul
    echo %case%|findstr "\<%ch%\>">nul&if errorlevel 1 goto :err
    goto %ch%
    goto err
    :h
    :: "寢室"
    echo "configure home ip address gateway,please wait 30 second ..."
    @netsh int ip set address "本地連接" static 66.168.1.8 255.255.255.0 66.168.1.1 1 >nul
    @netsh int ip set dns "本地連接" static 66.168.1.1 PRIMARY >nul
    echo home ip configure is done
    goto :EOF
    :r
    :: "公司網絡"
    echo "configure transport ip address gateway,please wait 30 second ..."
    @netsh int ip set address "本地連接" static 192.168.250.173 255.255.255.0 192.168.250.1 1 >nul
    echo transport ip configure is done
    goto :EOF
    :d
    :DHCP "自動獲取IP地址"
    echo "configure transport ip address gateway,please wait 30 second ..."
    @netsh int ip set address "本地連接" dhcp >nul
    @netsh int ip set dns "本地連接" dhcp >nul
    :err
    :: "error"
    echo your input "%ch%" ,no this argument ! please input h or w! game over
    rem # 接口 IP 配置結束